The SRP Series

SRP Servoreelers respond to "pull" commands creating an almost organic feel and response. A user pulls the desired amount of cable out and that length will remain.

Once at the desired length, the cable may still be pulled and extended further or pulled and released to allow the cable to retract to its stored position.

Available models are:

SRP-8, with 8' of extension
SRP-20, with 20' of extension

All literature can be obtained on the Downloads page.

Servoreelers permit smooth deployment and retraction without the use of contacts or slip rings thus eliminating any potential for noise contamination.
Quiet mechanical operation: The servo-motor is shock mounted to assure low acoustic coupling.
External TTL compatible-retract command input: Provides automatic retraction when a microphone is replaced in a cradle equipped with a hang-up sensor switch.
Power-up inhibit function: Prevents retraction on power-up if Servoreeler cables have been left extended. This can be important in centrally powered systems, where a mass retraction could result in a large current surge.
Power-Off cable control: This prevents internal cable spillage should the cable be pulled when the power is off.
Automatic end of reel retract (2 or 3 turns) and stop: Maintains ability to re-start by pull command.
Can operate in any orientation: Normal cable feed is with the Servoreeler vertical; Horizontal operation is optional.
High quality microphone cable: 2mm, 2 conductor, satin black, very compliant, shielded and Kevlar reinforced.
Long cable life: Gentle internal cable handling resulting in extremely low cable wear.
No maintenance is required: All rotating components employ sealed precision ball bearings.
High MTBF: Installed systems have demonstrated failure rates of zero to one (1) failure in 3,000,000 operating hrs.
Provided with a one (1) year warranty on parts and labor; excluding damage to the microphone cable.